Designing a model of a fitness device

The project is to be an enclosure for an exercise treadmill (sample photos attached). Below are the details:

- the model consists of an enclosure, a door, an enclosure for the IR illuminator and the floor;

- the whole can have a maximum width of 80 cm (without removable parts);

- the floor is higher on the inside and lower on the outside so that when applying the enclosure it makes a guide; _|-----|_

- the floor must allow the installation of Kandahar;

- housing one-sided smooth;

- floor smooth on one side;

- the enclosure at the back must have a step (under which the runner is inserted);

- the enclosure at the top has an opening surrounded by a flange;

- this hole should come out in the middle of the treadmill so as to allow free running on the treadmill without hitting the door;

- the flange is used to apply a material to seal the interior for training;

- the housing at the front (inside) must have space to hide the electronics and vacuum pump;

- the space to hide the electronics is closed with an additional wall (wall with gasket);

- the electronics has dimension: 18 cm x 24 cm x 10 cm;

- the pump has dimension: FI15 cm x 20 cm [h].

... more to be discussed later